Fibaro 2 x 1.5kW Relay Switch

The FIBARO Double On/Off Relay Switch is small enough to be installed inside a back box or anywhere that requires control of up to two independent devices (up to 1500W each).

The Fibaro Double On/Off Relay Switch can control a connected device either wirelessly or via the switch connected to the module

The Fibaro Double Relay utilises MESH technology and retransmits your instructions to other Z-WAVE controlled units

Please note, This device must be installed by a licensed electrician, before contracting an electrician please check that they provide a warranty and electrical compliance certificate

You must provide a installation compliance certificate from your electrician for warranty claims.

Contact us for a supply & installed quote

• Requires 3-wire (including neutral) installation
• Can use mains or alternative power supply for load (including DC)
• Works with AC or DC power supply (110-230V AC or 24-60V DC)
• Second switch input for controlling additional associated devices or 2-way installations
• Can be controlled and associated with other Fibaro devices and Z-Wave controllers
• It is considered to be the smallest device of its type in the world

Power Source: 110V – 230V +/-10% 50/60Hz,

Power Source: 24 – 60V DC ±10%,

Max. AC output: 8A / 230V 50/60Hz,

Max. DC output: 8A / 30V,

Max. Power output (resistive loads only): 2 x 1.5 kW (in case of loads other than resistive it may be necessary to connect lower output in order to protect the Switch from damage),

Overheating protection: safety off at 105°C,

Ambient temperature: 10°C – 40°C,

Radio protocol: Z-Wave,

Radio Frequency: 921.42Mhz – AU/NZ

Antenna range: up to ca. 50 meters outdoors, or up to 30 meters indoors (depends on building structure),

External Dimensions: (L x W x H) 42,5mm x 38,25mm x 20,3mm.